Re-Enable Cryptography After It Has Been Disabled - Digi IX10 User Manual

System administration
The device is reset to the default configuration and rebooted.
n
After the reboot:
n
Access to the device via the WebUI and SSH are disabled.
l
All internet connectivity is disabled, including WAN and WWAN. Connectivity to central
l
management software is also disabled.
All IP networks and addresses are disabled except for the default 192.168.210.1/24
l
network on the local LAN Ethernet port. DHCP server is also disabled.
The device can only be accessed by using telnet from a local machine connecting to the
192.168.210.1/24 network.
Disabling device encryption is not available in the WebUI. It can only be performed from the Admin CLI.

Command line
1. Log into the IX10 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Disable encryption with the following command:
> system disable-cryptography
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Re-enable cryptography after it has been disabled.

To re-enable cryptography:
1. Configure your PC network to connect to the 192.168.210 subnet. For example, on a Windows
PC:
IX10 User Guide
Disable device encryption
488