Digi IX10 User Manual page 426

User authentication
iii. Verify that the admin group has Admin access enabled. If not, click Admin access to
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
7. Click Apply to save the configuration and apply the change.

Command line
1. Configure a user on the RADIUS server:
a. On the ubuntu machine hosting the FreeRadius server, open the
/etc/freeradius/3.0/users file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUS user to the users file:
admin1 Cleartext-Password := "password1"
In this example:
n
n
n
c. Save and close the users file.
2. Configure a user on the TACACS+ server:
a. On the ubuntu machine hosting the TACACS+ server, open the /etc/tacacs+/tac_plus.conf
file:
$ sudo gedit /etc/tacacs+/tac_plus.conf
b. Add a TACACS+ user to the tac_plus.conf file:
user = admin1 {
}
In this example:
n
n
IX10 User Guide
Unix-FTP-Group-Names := "admin"
The user's username is admin1.
The user's password is password1.
The authentication group on the IX10 device, admin, is identified in the Unix-FTP-
Group-Names parameter.
name ="Admin1 for TX64"
pap = cleartext password1
service = system {
groupname = admin
}
}
The user's username is admin1.
The user's password is password1.
Example user configuration
426