Digi IX10 User Manual page 270

Services
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the SSH service:
To enable the service:
n
(config)> service ssh enable true
(config)>
To disable the sevice:
n
(config)> service ssh enable false
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the service

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > SSH.
4. (Optional) For Port, enter the port number for the service. Normally this should not be
changed.
5. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click .
IX10 User Guide
Configure SSH access
270