Digi IX10 User Manual page 240

Virtual Private Networks (VPN)

WebUI
1. Click VPN > IP Tunnels.
2. For Add IP Tunnel, type gre_tunnel1 and click .
3. For Local endpoint, select the IPsec endpoint interface created in
ipsec_endpoint1).
4. For Remote endpoint, type the IP address of the GRE tunnel on IX10-2, 172.30.0.2.
5. Click Apply to save the configuration and apply the change.

Command line
1. At the command line, type config to enter configuration mode:
> config
(config)>
2. Add a GRE tunnel named gre_tunnel1:
(config)> add vpn iptunnel gre_tunnel1
(config vpn iptunnel gre_tunnel1)>
3. Set the local endpoint to the IPsec endpoint interface created in
(/network/interface/ipsec_endpoint1):
(config vpn iptunnel gre_tunnel1)> local /network/interface/ipsec_endpoint1
(config vpn iptunnel gre_tunnel1)>
4. Set the remote endpoint to the IP address of the GRE tunnel on IX10-2, 172.30.0.2:
(config vpn iptunnel gre_tunnel1)> remote 172.30.0.2
(config vpn iptunnel gre_tunnel1)>
IX10 User Guide
Generic Routing Encapsulation (GRE)
Task two (Interface:
Task two
240