Digi IX10 User Manual page 112

Serial port
a. For Copy Port 1 configuration to these ports:, type the names of the ports that the
configuration should be copied to.
b. For Copy these settings, select the types of settings that should be copied to the selected
ports.
c. Click Copy.
9. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
IX10 User Guide
Configure the serial port
112