Digi IX10 User Manual page 70

Interfaces
iii. For Interface, select Interface: WWAN_Private.
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the maximum number of interfaces for the modem:
(config)> network modem modem max_intfs 2
(config)>
4. Create the WWAN interfaces:
a. Create the WWANPublic interface:
(config)> add network interface WWANPublic
(config network interface WWANPublic)>
b. Set the interface type to modem:
(config network interface WWANPublic)> type modem
(config network interface WWANPublic)>
c. Set the modem device:
(config network interface WWANPublic)> modem device modem
(config network interface WWANPublic)>
d. (Optional): Set the public APN. If the public APN is not configured, the IX10 will attempt to
determine the APN.
IX10 User Guide
Wireless Wide Area Networks (WWANs)
70