Configure Packet Capture For The Network Analyzer - Digi IX10 User Manual

Diagnostics

Configure packet capture for the network analyzer

To use the network analyzer, you must create one or more packet capture configuration.
Required configuration items
The interface used by this packet capture configuration.
n
Additional configuration items
The filter expression for this packet capture configuration.
n
Schedule the analyzer to run based on a specified event or at a particular time:
n
The events or time that will trigger the analyzer to run, using this capture configuration.
l
The amount of time that the analyzer session will run.
l
The frequency with which captured events will be saved.
l
To configure a packet capture configuration:

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Analyzer.
4. For Add Capture settings, type a name for the capture filter and click .
The new capture filter configuration is displayed.
IX10 User Guide
Analyze network traffic
544