Table of Contents
Advertisement
[Supplementary Explanation]
-
When the parameter "aaaa" and "bbbbb" are not specified, all print data specified prior to this
command will be rotated.
-
Data outside of printing area will not rotate.
-
If specifying this command for the item that does not contain print data, the command error will
occur.
-
This command cannot be used in combination with the commands that associated with reedition
of print data. Refer to the invalid commands list below. When the command that cannot use in
combination with is specified, print result is not guaranteed.
-
This command cannot be used in combination with some registration commands. Refer to
the invalid commands list below. When the command that cannot use in combination with is
specified, print result is not guaranteed.
-
This command cannot be used in combination with some of the modification commands. Refer
to the invalid commands list below. When the command that cannot use in combination with is
specified, print result is not guaranteed.
-
This command prints the mirror image of the print data put before the mirror rotation command
is specified. The data after the command does not rotate. Note that specifying this command
several times results rotating the data several times.
-
When the mirror image is applied for the barcode, reading of the barcode and the head damage
check are not guaranteed.
-
When executing the mirror image, the head damage check will be performed for all the areas
where rotated.
[Valid Range for mirror rotation]
Horizontal range of mirror rotation: 8 to 3200 dots
Vertical range of mirror rotation: 8 to 3600 dots
[Invalid Commands]
Command that
<WD>
associated with
reediting.
Registration
<GI>
Modification
<%>
<F>
<(>
<0>
<GT>
<PI>
<WA>
56
Advertisement
Table of Contents
