Table of Contents
Advertisement
[Supplementary Explanation]
-
The inter-character pitch of the barcode is valid at CODABAR (NW-7), CODE39, Industrial 2of5
and Matrix 2of5. The barcode inter-character pitch is set by specifying the character pitch <P>
immediately before.
If not set, the inter-character pitch will be of the same size as a narrow space and will become
multiples of a narrow bar.
e.g.)
Command
<BT>
-
If there is no Registration of Bar Width Ratio <BT>, barcode based on pre-registered bar
width ratio of narrow and wide bars will be printed. Note that specification of <BT> is required
beforehand to print.
-
For print data of each barcode type, refer to the code tables of barcode.
[Notes]
-
If the value other than valid range is set, command error will occur and barcode will not be
printed.
-
A barcode that exceeds the printable area will not be printed.
-
Increasing narrow bar width may exceed the printing area and may not be printed.
-
Scanner may not read the barcode with valid character pitch when Character Pitch <P> is
increased. Also, increasing the narrow bar width may cause the same type of problem. For
more information, refer to the documentation of your scanner.
-
For specifying the narrow bar width, consider the reading compatibility of scanner and head
density beforehand.
-
Adjust Print Speed <CS> or Print Darkness <#F> if there is a problem in barcode reading.
-
Matrix 2of5 will be expressed as Coop2of5/NEC2of5.
-
If Start/Stop character is not included in print data at the time of CODABAR (NW-7) or CODE39
specified, barcode will be printed; however, scanner cannot read it.
Ratio
Narrow
space width
3:5
3
<P>
specification
Narrow bar
width is [1]
None
3
<P>0
3
<P>1
1
<P>2
2
<P>3
3
<P>4
4
183
Gap between characters
Narrow bar width is [2]
6
6
2
4
6
8
Advertisement
Table of Contents
