Table of Contents
Advertisement
[Supplementary Explanation]
-
Set the external signal output for "DISABLE" in the advanced mode when using this External
Signal Input/Output <IO>. When it is set to "ENABLE", the signal changes regardless with this
command because the signal is output on the printer.
-
The timing of signal output is not related the print operation of the printer but when this
command is processed.
-
Refer to [Input or Output] described below for input or output.
-
There may be about 5 msec margin of error in the specified output time and the actual signal
output time.
-
When the output level and the current output level is the same, the output level will not be
changed even the specified output time has passed.
[Input or Output]
Pin number
1
2
3
4
5
6
7
*1 Input/Output of the PIN 9 of the 14 pin-connector can be selected by Jumper SW (JP2) on the external signal interface
board.
Input or Output : 14 pins
Output
-
Output
Output
Input
Output
Input
397
Pin number
8
9
10
11
12
13
14
Input or Output : 14 pins
-
*1
Input/Output
Output
Input
-
-
-
Advertisement
Table of Contents
