Table of Contents
Advertisement
[ESC+E] Auto Line Feed
Hexadecimal code
Initial value
Valid range and term of
command
[Function]
Specifies amount of line spacing and CR (Line feed).
[Format]
<E>aaa
-
Parameter
a [line spacing] = valid range : 0 to 999 dots
[Coding Example]
<A>
<E>10
<V>100<H>200<P>2<L>0304<XM>ABCDE+CR
FGHIJ+CR
<Q>2
<Z>
[Supplementary Explanation]
-
When CR (0DH) is specified, linefeed based on line pitch will be performed.
-
Rotation <%> can be used in combination with this command.
-
This command may be used in a job and change the line spacing as necessary.
-
Specify this command before designating the consecutive print of 1-line.
-
Specifying font command executes the line feed regardless of CR/LF deletion setting.
-
Performing auto linefeed by the designation of CR (0DH), print start position of linefeed will be
determined based on the pitch specified with Auto Line Feed <E> and the value specified with
Horizontal Print Position <H> designated after Auto Line Feed <E>. In case that Print Position
<H> is specified several times after Auto Line Feed <E>, return position by CR (0DH) will be at
the end of Print Position <H>.
ESC
<1B>
16
None
When the power is OFF
Valid range within items
Valid range between items
E
<45>
16
The set parameter is not maintained.
The set parameter becomes invalid.
The set parameter becomes invalid.
324
Parameter
aaa
Advertisement
Table of Contents
