Connecting The Supply Cable - WAGO -SPEEDWAY 767 Manual

44 Connecting Data and Supply Cables
Pos : 23.15 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlus s_Spannungs vers orgung 767- 4803, - 4804 @ 5\mod_1249306158703_21.doc x @ 40087 @ 2 @ 1
5.4

Connecting the Supply Cable

The supply cable provides power to the module.
Retransmission of power supply not possible!
Because of the module's increased output current of 2 A for each channel,
retransmission of the power supply is not possible. It has two IN connections as a
result of the increased power requirement. For subsequent modules, the power
supply must therefore be newly fed.
Requirement:
The WAGO supply cables K1 and K2, which are pre-assembled on both ends,
must be available (see Fig. 15). The following table outlines the assignment of the
supply connections. Please note that you supply the 24 V for U
connections from one power supply and 24 V for U
from one power supply. In addition, the supply lines must have the same line
resistance (same length and cross section) to achieve an equal current distribution
to the supply connections.
Table 1: Supply connection assignment
Connection
IN(K2)
IN(K3)
Pos : 23.16 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Ac htung/Ac htung: Höchs te Strombel astbar keit der Vers orgungs kontakte @ 8\mod_1278308653219_21.doc x @ 58916 @ @ 1
The highest current carrying capacity of the supply contacts is 4 A!
Always observe the maximum current carrying capacity per supply line (U
for each 767 Series component and the overall power consumption for all
767 components. Neither of these values shall exceed 4 A since an increase in
current causes the contacts to overheat and damages the 767 Series components.
Information regarding the power demand of each 767 Series component can be
found in the corresponding data sheet, which is available from www.wago.com.
Pos : 23.17 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
767-4804/000-800 8DO 24V DC 2.0A IF (4xM12)
Contact Description
1 24 V DC U
2 24 V DC U
3 0 V U
LS
4 0 V U
A
1 24 V DC U
2 24 V DC U
3 0 V U
LS
4 0 V U
A
WAGO-SPEEDWAY 767
LS
of both IN connections also
A
LS
A
LS
A
of both IN
, U )
LS A
Manual
Version 1.1.0