Address Selection Switch; Figure 32: Address Selection Switch (For Example Setting "0"); Table 21: Meaning Of Dip Switch Positions - WAGO 750-363/0040-0000 Manual

60 Device Description
4.4.2

Address Selection Switch

Figure 32: Address Selection Switch (for example setting "0")

The 8-pole DIP switch is used to select the protocol for setting the IP address
and as an address selection switch, to set the IP address.
The IP address is composed of a network component and a host component.
Network
192. 168.
The network component is configurable and in delivery status 192.168.1.
The host component is set via the DIP switches of the address selection switch.
The coding with the DIP switches is bit-wise, starting with DIP switch 1 with the
least significant bit (2
corresponding to the values 0 to 255.

Table 21: Meaning of DIP Switch Positions

DIP Switch
Positions
(ON = 1)
00000000
00000001...
11111110
11111111
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
Host
1. 0 ... 255
0 ) to DIP switch 8 with the most significant bit (2
Value Meaning
The IP configuration set in the WBM on the
0
"Port" WBM page is used (default DHCP, but
(WBM) can be changed to BootP or EEPROM).
Host component by switch position
1-254 Example of setting the DIP switch:
Host For the IP address 192.168.1.33, the 1st and
component 6th switches must be set: 2
(6th switch) = 33
255 The DHCP protocol is used to configure the IP
(DHCP) parameters.
WAGO-I/O-SYSTEM 750
7 ),
0 (1st switch) + 2 5