Di Module" Mode; Dio Module" Mode; Table 34: Overview Of Adjustable Parameters For The Digital Inputs - WAGO 767-5803 Manual

60 Parameterizing
7.2.3

"DI Module" Mode

Table 34: Overview of adjustable parameters for the digital inputs

Parameter
Function mode
Designation
Input value
Signal inverting
Filter time
Simulation input value
* Default status
7.2.4

"DIO Module" Mode

Combined operation of digital inputs and outputs. For an explanation of the
adjustable parameters for the digital outputs, see section "DO Module" and for the
digital inputs section "DI Module".
Description
Mode display
Electronic marking field (max. 40 characters)
The input state is indicated in this box.
When simulation is switched on, the field becomes a checkbox.
Activate this checkbox to simulate input state "1" independently from the
input in the process image.
You can invert the currently pending input signal here.
Checkbox unselected*:
Input signal is reproduced in the process image in the same manner as the
input
Checkbox selected:
Input signal is reproduced in the process image in an inverted manner
Set the input filter for the measured signals here. You have the following
options:
none
0.1 ms
0.5 ms
3 ms*
15 ms
20 ms
Activate this checkbox to switch input simulation on. The field for the
input value then becomes a checkbox for the simulation value.
WAGO-SPEEDWAY 767
767-5803 8DIO 24V DC 0,5A (8xM12)
Manual
Version 1.1.0