Custom Playback Lists - Quantum Data Gen 2 980 User Manual

980 HDMI Protocol Analyzer User Guide
4. From the pscope prompt enter the command to stop and save the file for playback. Ten (10) frames are saved
in the example below.
#p-scope>pcap save 10 MyCap1.pb
Note: When you save a playback file using these Console commands the files are saved in the /qd directory
not the /workspace/playback/ as the playback files created through the GUI are saved. Therefore you will not
be able to see these playback files through the GUI. Similarly you will have to navigate through the file system
to access playback files created through the 980 GUI Manager if you wish to use them on the command line.
You can locate files using the following command:
#p-scope>exec ls /qd/*.pb
15.2.2 Replaying a Playback file through the command line
This subsection describes how you can replay a playback file through the command line.
To replay a playback file through the command line:
1. From the pscope prompt in the 980 GUI Manager Console, enter the following command to replay the
playback file.
Note: You enter commands in the Command field near the top of the Console panel.
#p-scope>play MyCap1.pb
2. To pause the playback of a file, use the following command.
#p-scope>play pause
3. To resume the playback of a paused file, use the following command.
#p-scope>play resume
4. To stop the playback use the following command.
#p-scope>play stop

15.3 Custom Playback lists

Use the following procedures to create a custom playback list. The Playback List Editor can be used either on the
embedded 980 GUI Manager or the external 980 GUI Manager. The examples in this procedure use the external
980 GUI Manager.
15.3.1 Creating a custom playback list
This subsection describes how you can create a playback list.
To create a playback list:
1. From the Main window of the 980 GUI Manager, select Playback List Editor from the View menu as shown
below.
Page 290
Rev. A1
December 19, 2012