Table of Contents
Advertisement
Do You Have Everything?
FieldFox –To check for installed options, press
System then
Options
Phase stable jumper cable or adapters – Used to
connect the FieldFox to devices with various
connector types and gender.
Attenuators – Reduces power and prevents
damage to the FieldFox at the test ports.
Cal Kit – T-Calibration Kits or other devices.
MicroSD card or USB flash drive – Save files to
these devices for quick download to a PC.
USB Power Sensor – For making Power Meter
measurements. (Opt 302)
Battery charger or extra battery
The Power Button and LED
To turn power ON, briefly press the power button.
The LED is green. The boot-up takes about 60
seconds.
To switch to Stand by power (low battery drain)
briefly press the power button. The LED is amber and
blinks slowly. To turn power ON, briefly press the
power button. Power and settings are restored
instantly.
To turn Power OFF (very low battery drain) press and
hold the power button until power is shut OFF -
about 4 seconds. The LED is OFF.
System Configuration
then
Show Options
2
then
Advertisement
Table of Contents
