Figure 7-7.Sio Active Mode Output Timing, 16-Bit Words - Lucent Technologies DSP1617 Information Manual

Digital signal processor
Table of Contents

Advertisement

Information Manual
April 1998
7.1 SIO Operation
(continued)
7.1.3 Output Section (continued)
A serial address (SADD) transmits simultaneously with DO. The low-order 8 bits of this address are the transmit
address field of the srta register (bits 7—0) (see
the low byte of the saddx register (bits 7—0). The SADD output is primarily intended for use in multiprocessor
mode and
Section 7.6, Multiprocessor Mode Description
SADD output can also be used as a second serial output only port if not in multiprocessor mode because the
SADD signal remains valid. (Do not confuse this with SIO2; SADD is a different port from the SIOs.)
If SADD is to be used as a second data port, the LD bit of the sioc register (bit 9) must be set high to synchronize
SADD with DO and the MODE bit of the tdms register (bit 8) must be set low to turn off multiprocessor mode.
Under these conditions, arbitrary values can safely be written to the srta register (low byte) and saddx register (low
byte) for 16-bit output transmissions. The high bytes of srta and saddx will be ignored in this application.
Note: The SADD output is active-low (inverted data). SADD must be pulled high through a resistor for multiproces-
sor applications.
The DOEN signal asynchronously enables the DO and SADD 3-state output buffers if active. Its operation is inde-
pendent of any other SIO signals.
Figure 7-7
shows the timing relationships for the SIO output port signals in active mode (active mode is defined
here as OLD being supplied by the DSP). The primary difference from passive mode is that OCK now drives OLD
and OLD is known to be a square wave.
OCK
OLD
DRIVE
DO
B0
B1
SADD
AD0
OSE
OBE
DOEN
Lucent Technologies Inc.
DSP1611/17/18/27/28/29 DIGITAL SIGNAL PROCESSOR
Table
B2 B3
AD7 AS0
Figure 7-7. SIO Active Mode Output Timing, 16-bit Words
DRAFT COPY
7-6). The high-order 8 bits of this address are obtained from
should be consulted for its use in this application. The
B15
B1
B0
AS7 AD0
Serial I/O
3-STATE
AD7
5-4177
7-7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsp1629Dsp1618Dsp1611Dsp1627Dsp1628

Table of Contents