Table of Contents
Advertisement
PARTNER Voice Messaging Installation and Programming
For Call Answer Service, program the following communications system features:
Line Coverage Extension (#208)
Automatic VMS Cover (#310)
VMS Cover Rings (#117) (#321 on PARTNER ACS Release 3.0 or later)
You may also perform Telephone Button Programming for Manual VMS Cover (F15), Do Not
Disturb (F01), Voice Mailbox Transfer (F14), Voice Mail Auto Dial (I777).
Using Communications Systems
Programming
You can program the communications system from extension 10 or extension 11. You may find it
more convenient to program from extension 11. This capability allows the receptionist to continue
handling calls at extension 10 while you program.
System Programming requires a system display phone at extension 10 or extension 11, with a
programming overlay placed over the phone's dialpad. System Programming procedures are
identified by # and a 3-digit code (for example, the procedure code for System Date is #101).
System Programming changes settings for the system as a whole, or for individual lines or
extensions. (Refer to the documentation for the PARTNER communications system for more
information about System Programming options.)
You can talk on the telephone while you program. This is useful if you need to call for support while
programming. However, you must place the call before you enter programming mode, and you must
use the handset (not the speakerphone) to talk.
Entering System Programming Mode
To enter system programming mode:
1. At extension 10 or 11, make sure the programming overlay is in place over the system phone's
dialpad.
2. Press f00 .
3. Press ss .
4. Enter specific programming procedure codes.
Using Communications Systems Programming
28
Advertisement
Table of Contents
