Table of Contents
Advertisement
Programming
Using Communications Systems
Programming
You can program the communications system from extension 10 or extension 11.
You may find it more convenient to program from extension 11. This capability
allows the receptionist to continue handling calls at extension 10 while you
program.
System Programming requires a system display phone at extension 10 or
extension 11, with a programming overlay placed over the phone's dialpad.
System Programming procedures are identified by # and a 3-digit code (for
example, the procedure code for System Date is #101).
System Programming changes settings for the system as a whole, or for
individual lines or extensions. (Refer to the Programming and Use guide for the
PARTNER ACS system or PARTNER Endeavor system for more information about
System Programming options.)
NOTE:
You can talk on the telephone while you program. This is useful if you need
to call for support while programming. However, you must place the call
before you enter programming mode, and you must use the handset (not
the speakerphone) to talk.
System Programming Mode
To enter system programming mode:
1. At extension 10 or 11, make sure the programming overlay is in place over
the system phone's dialpad.
2. Press f00.
3. Press ss.
4. Enter specific programming procedure codes.
4-12
Issue 1 August 1998
Advertisement
Table of Contents
