Suzuki Baleno Manual page 2079

SCAN TOOL DATA
As the data values given below are standard values estimated on the basis of values obtained from the normally
operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good condition,
there may be cases where the checked value does not fall within each specified data range. Therefore, judgment
as abnormal should not be made by checking with these data alone.
Also, conditions in the below table that can be checked by the scan tool are those detected by ECM and output
from ECM as commands and there may be cases where the engine or actuator is not operating (in the condition)
as indicated by the scan tool.
NOTE:
D When checking the data with the engine running at idle or racing, be sure to shift M/T gear to the neutral
gear position and pull the parking brake fully. Also, if nothing or "no load" is indicated, turn OFF A/C,
all electric loads, P/S and all the other necessary switches.
SCAN TOOL DATA
CALC LOAD
(CALCULATED ENGINE LOAD VALUE)
COOLANT TEMP. SENSOR VOLTAGE
(ENGINE COOLANT TEMPERATURE
SENSOR)
ENGINE SPEED
INJECTION TIMING INJECTION TIMING
THROTTLE POS SENSOR VOLTAGE
(THROTTLE POSITION SENSOR)
BATTERY VOLTAGE
BAROMETRIC PRESSURE VOLTAGE
INJECTOR NEEDLE SENSOR VOLTAGE
ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-25
CONDITION
At specified idle speed with no load after
warming up
At 2000 r / min with no load after warming
up
At specified idle speed after warming up
At idling with no load after warming up
At specified idle speed with no load after
warming up
At 2000 r/min with no load after warming
up
Throttle valve fully closed
Throttle valve fully open
Ignition switch ON/engine stop
Ignition switch ON
At specified idle speed with no load after
warming up
REFERENCE VALUES
4 – 5 mg/str
6 – 7 mg/str
0.1 V
(80 – 100_C,
176 – 212_F)
Desired idle speed
50 r / min
3 – 4 deg
6 – 7 deg
0.6 – 1.0 V
2.4 – 2.8 V
12 – 15 V
Display the barometric
pressure voltage
0.8 – 1.2 V