Honda NSX-T 1998 Manual page 289

Main Menu
Manual Steering
Overhaul (Cont'd)
• If the pinion bearing is noisy or has excessive
play, replace the bearing using the special tools
and a press.
NOTE: Hold the outer race with the tool securely.
• Press the steering pinion into the new pinion
bearing.
NOTE:
• Install the pinion bearing with the wider side of
the inner race toward the gear.
• Hold the inner race with the tool securely.
Table of Contents
HUB DIS/ASSEMBLY BASE
07GAF-SD40700
HUB DIS/ASSEMBLY BASE
07GAF-SD40700
10. Remove the steering rack from the cylinder
housing.
NOTE: The steering rack cannot be removed from
the cylinder side.
• Check the lower bearing and replace it if it is
damaged.
Remove the lower bearing by lightly tapping
with a plastic hammer as shown. If the lower
bearing is hard to remove by tapping, heat the
gearbox by soaking it in 212°F (100°C) water.
CAUTION: To avoid burns, use heavy gloves when
handling the heated gearbox.