Compatible SCPI Commands
Supported SCPI Commands
ABORt
Aborts any current measurement and resets the trigger system.
Remote Command
Example
Remote Command Notes
CALCulate:DELTamarker Subsystem
The CALCulate:DELTamarker subsystem controls the delta-marker functions.
NOTE
CALCulate<1|2>:DELTamarker<1...4>[:STATe] ON | OFF
When delta marker 1 is selected, this command switches the delta marker on and off.
When any one of delta markers 2 through 4 is selected, that marker becomes the delta marker. If the
marker was not activated, it becomes activated, and is placed at the maximum of the measurement curve.
If the numeric suffix is omitted, delta marker 1 is automatically selected.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
CALCulate<1|2>:DELTamarker<1...4>:MODE ABSolute|RELative
The command switches the frequency input of the delta marker between Absolute and Relative modes.
The query returns the current state of this setting.
Remote Command
Example
60
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:ABORt
:ABOR
FSE, FSP, FSU
All delta marker functions are not supported in the CCDF and APD measurements.
:CALCulate[1]:DELTamarker[1]|2|3|4[:STATe] ON|OFF|1|0
:CALCulate[1]:DELTamarker[1]|2|3|4[:STATe]?
CALC:DELT ON
FSE, FSP, FSU
OFF
Saved in instrument state.
:CALCulate[1]:DELTamarker[1]|2|3|4:MODE
ABSolute|RELative
:CALCulate[1]:DELTamarker[1]|2|3|4:MODE?
CALC:DELT:MODE ABS
CALC:DELT:MODE REL
CALC:DELT:MODE?