Agilent Technologies X Series User Manual page 40

Table 3-1
SCPI Command
CALCulate<1|2>:DELTamarker<1...4>:MINimu
m:RIGHt
CALCulate<1|2>:DELTamarker<1...4>:LINK
ON | OFF
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:FIXed[:STATe] ON | OFF
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:FIXed:RPOint:MAXimum[:PEAK]
<numeric_value>
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:FIXed:RPOint:Y <numeric_value>
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:FIXed:RPOint:Y:OFFSet <numeric_value>
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:FIXed:RPOint:X <numeric_value>
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:PNOise[:STATe]
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:PNOise:AUTO ON | OFF
CALCulate<1|2>:DELTamarker<1...4>:FUNCtio
n:PNOise:RESult?
CALCulate<1|2>:LIMit<1...8>:ACTive?
CALCulate<1|2>:LIMit<1...8>:TRACe 1 to 3
CALCulate<1|2>:LIMit<1...8>:STATe ON | OFF
CALCulate<1|2>:LIMit<1...8>:UNIT DBM |
DBPW | WATT | DBUV | DBMV | VOLT |DBUA
| AMPere| DB | DEG | RAD | S | HZ | PCT |
UNITLESS
CALCulate<1|2>:LIMit<1...8>:FAIL?
CALCulate<1|2>:LIMit<1...8>:CLEar[:IMMedia
te]
CALCulate<1|2>:LIMit<1...8>:COMMent
<string>
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
SCPI Commands Summary Table
Compatible SCPI Commands
Corresponding Support
Model
FSE/FSP/FSU Yes
FSU Yes
FSE/FSP/FSU Yes
FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSU Yes
FSE/FSP/FSU Yes
FSE/FSU a
Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
SCPI Summary Table
Notes
All LIMit functions are not
supported in CCDF and
APD measurements.
The units supported are
DBM, DBPW, WATT,
DBUV, DBMV, VOLT,
DBUA, and DB.
All limit lines use the same
unit.
39