Calculate<1|2>:Marker<1 - Agilent Technologies X Series User Manual

Compatible SCPI Commands
Supported SCPI Commands
This command is accepted, but takes no action and reports no error.
Remote Command
Example
Remote Command Notes
Min
Max
CALCulate<1|2>:MARKer<1...4>:MAXimum[:PEAK]
Places the delta marker at the current maximum on the measured curve. If required, the delta marker is
first activated.
This command is an event, and therefore has no *RST value and no query.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:MAXimum:NEXT
Places the marker at the next smaller maximum value of the corresponding trace.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:MAXimum:LEFT
Places the marker at the next smaller maximum to the left of the current value (that is, in order of
decreasing X values) on the trace.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:MAXimum:RIGHt
Places the delta marker at the next smaller maximum to the right of the current value (that is, in order of
increasing X values). If required, the corresponding delta marker is first activated.
90
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:CALCulate[1]:MARKer[1]|2|3|4:Y:PERCent <float>
:CALCulate[1]:MARKer[1]|2|3|4:Y:PERCent?
CALC:MARK2:Y:PERC 95PCT
FSP, FSU
0
100
:CALCulate[1]:MARKer[1]|2|3|4:MAXimum[:PEAK]
CALC:MARK:MAX
FSE, FSP, FSU
:CALCulate[1]:MARKer[1]|2|3|4:MAXimum:NEXT
CALC:MARK:MAX:NEXT
FSE, FSP, FSU
:CALCulate[1]:MARKer[1]|2|3|4:MAXimum:LEFT
CALC:MARK:MAX:LEFT
FSE, FSP, FSU