Calculate<1|2>:Limit<1; Calculate:limit:espectrum Subsystem - Agilent Technologies X Series User Manual

CALCulate<1|2>:LIMit<1...6>:DELete
Deletes the specified limit line.
Remote Command
Example
Remote Command Notes

CALCulate:LIMit:ESPectrum Subsystem

The CALCulate:LIMit:SPECtrum subsystem defines the limit check for spectrum emission
measurements.
The following SCPI commands of this subsystem are accepted by the analyzer, but result in no action,
and report no error.
CALCulate<1|2>:LIMit<1...6>:ESPectrum:MODE AUTO | MANual | USER
This command is accepted, but takes no action and reports no error.
Remote Command
Example
Remote Command Notes
Preset
State Saved
Range
CALCulate<1|2>:LIMit<1...6>:ESPectrum:VALue <numeric_value>
Sets manual limit line selection. The limit line is selected by specifying the expected dBm power.
This command is accepted, but takes no action and reports no error.
Remote Command
Example
Remote Command Notes
Preset
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:CALCulate[1]:LIMit[1]|2|3|4|5|6:DELete
CALC:LIM:DEL
FSE, FSP, FSU
:CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:MODE
AUTO|MANual|USER
:CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:MODE?
CALC:LIM:ESP:MODE AUTO
CALC:LIM:ESP:MODE
FSP
AUTO
Saved in instrument state.
AUTO | MANual | USER
:CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:VALue
<integer>
:CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:VALue?
CALC:LIM:ESP:VAL 39
CALC:LIM:ESP:VAL?
FSP
0
Compatible SCPI Commands
Supported SCPI Commands
71