Calculate<1|2>:Deltamarker<1; Calculate:limit Subsystem; Calculate<1|2>:Limit<1 - Agilent Technologies X Series User Manual

You can use this functionality to track a drifting source during a phase noise measurement. Delta marker
2, which shows the phase noise measurement result, retains the delta frequency value. Therefore the
results of phase noise measurement with a specified offset remain valid.
When marker 2 reaches the limit of the span, the delta marker value is automatically adjusted to be
within the span. In such cases, select a wider span.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:PNOise:RESult?
Queries the result of a phase noise measurement. If required, the measurement is switched on.
Remote Command
Example
Remote Command Notes

CALCulate:LIMit Subsystem

The CALCulate:LIMit subsystem includes the limit lines and limit checks. Limit lines may be defined as
upper or lower. The limit line Y-values correspond to the X-axis values. The number of x and y values
must be identical.
X Series Analyzers support up to 6 active limit lines at the same time.
CALCulate<1|2>:LIMit<1...6>:ACTive?
Queries the names of all active limit lines. For this command, all the numeric suffixes are ignored.
The return values are sorted alphabetically. If there are no active limit lines, an empty string is returned.
Remote Command
Example
Remote Command Notes
Preset
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:PNOise:AUTO
ON|OFF|1|0
:CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:PNOise:AUTO
?
CALC:DELT:FUNC:PNO:AUTO ON
FSU
OFF
Saved in instrument state.
:CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:PNOise:RESu
lt?
CALC:DELT:FUNC:PNO:RES?
FSE, FSP, FSU
:CALCulate[1]:LIMit[1]|2|3|4|5|6:ACTive?
CALC:LIM:ACT?
FSE, FSU
""
Compatible SCPI Commands
Supported SCPI Commands
67