Calculate:marker Subsystem; Calculate<1|2>:Marker<1 - Agilent Technologies X Series User Manual

Compatible SCPI Commands
Supported SCPI Commands

CALCulate:MARKer Subsystem

The CALCulate:MARKer subsystem controls marker functions in the instrument.
NOTE
CALCulate<1|2>:MARKer<1...4>[:STATe] ON | OFF
The command switches the specified marker on or off.
If no numeric suffix is supplied, marker 1 is selected automatically.
If marker 2, 3 or 4 is selected and used as a delta marker, it is switched to marker mode.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
CALCulate<1|2>:MARKer<1...4>:AOFF
Turns off all active markers.
All delta markers are turned off.
All active marker and delta marker measurement functions are turned off.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:TRACe 1 to 3
The command assigns the specified marker to the trace defined by the command parameter.
If required, the corresponding marker is turned on.
The query returns the current assignment.
Remote Command
Example
86
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
All marker functions are not supported in the CCDF and APD measurements.
:CALCulate[1]:MARKer[1]|2|3|4:STATe ON|OFF|1|0
:CALCulate[1]:MARKer[1]|2|3|4:STATe?
CALC:MARK3:STAT ON
FSE, FSP, FSU
OFF
Saved in instrument state.
:CALCulate[1]:MARKer[1]|2|3|4:AOFF
CALC:MARK:AOFF
FSE, FSP, FSU
:CALCulate[1]:MARKer[1]|2|3|4:TRACe 1|2|3
:CALCulate[1]:MARKer[1]|2|3|4:TRACe?
CALC:MARK:TRAC 2