Status:operation:ptransition; Status:operation:ntransition; Status:preset - Agilent Technologies X Series User Manual

STATus:OPERation:PTRansition

Specifies the edge detectors of all bits in the STATus:OPERation register from 0 to 1 for the transitions
of the CONDition bit.
This mode supports the maximum value of 32767, not 65535 as FSx.
Remote Command
Example
Remote Command Notes
Preset
Min
Max
SCPI Status Bits/OPC
Dependencies

STATus:OPERation:NTRansition

Specifies the edge detectors of all bits in the STATus:OPERation register from 1 to 0 for the transitions
of the CONDition bit.
This mode supports the maximum value of 32767, not 65535 as in FSx.
Mode
Remote Command
Example
Remote Command Notes
Preset
Min
Max
SCPI Status Bits/OPC
Dependencies

STATus:PRESet

Resets the edge detectors and ENABle parts of all registers to a defined value.
Remote Command
Example
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:STATus:OPERation:PTRansition <integer>
:STATus:OPERation:PTRansition?
STAT:OPER:PTR 1
FSE, FSP, FSU
32767
0
32767
Sequential command
All
:STATus:OPERation:NTRansition <integer>
:STATus:OPERation:NTRansition?
STAT:OPER:NTR 1
FSE, FSP, FSU
0
0
32767
Sequential command
:STATus:PRESet
STAT:PRES
Compatible SCPI Commands
Supported SCPI Commands
153