Mmemory:select[:Item]:None; Mmemory:select[:Item]:Default; Mmemory:comment <String; Sense:average Subsystem - Agilent Technologies X Series User Manual

MMEMory:SELect[:ITEM]:NONE

This command is accepted, but takes no action and reports no error.
Remote Command
Example
Remote Command Notes

MMEMory:SELect[:ITEM]:DEFault

This command is accepted, but takes no action and reports no error.
Remote Command
Example
Remote Command Notes
MMEMory:COMMent <string>
Specifies a comment (max. 60 characters), to be associated with a stored analyzer setting.
This command is accepted, but takes no action and reports no error.
Remote Command
Example
Remote Command Notes
State Saved

SENSe:AVERage Subsystem

The SENSe:AVERage subsystem calculates the acquired data average. After several successive
measurements, a new test result is obtained.
[SENSe<1|2>:]AVERage:COUNt 0 to 32767
Specifies the number of measurements that contribute to the average value.
In the SCPILC mode, the maximum value is 10000 and not 32767 as in FSx.
Remote Command
Example
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:MMEMory:SELect[:ITEM]:NONE
MMEM:SEL:NONE
FSE, FSP, FSU
:MMEMory:SELect[:ITEM]:DEFault
MMEM:SEL: DEF
FSE, FSP, FSU
:MMEMory:COMMent <string>
:MMEMory:COMMent?
MMEM:COMM 'Unknown Trace'
MMEM:COMM?
FSE, FSP, FSU
Saved in instrument state.
[:SENSe]:AVERage:COUNt
[:SENSe]:AVERage:COUNt?
SENS:AVER:COUN 10
SENS:AVER:COUN?
Compatible SCPI Commands
Supported SCPI Commands
<integer>
129