Calculate<1|2>:Marker<1 - Agilent Technologies X Series User Manual

Compatible SCPI Commands
Supported SCPI Commands
CALCulate<1|2>:MARKer<1...4>:MINimum[:PEAK]
Places the delta marker at the current maximum on the trace.
If required, the corresponding delta marker is first activated.
This command is an event, and therefore has no *RST value and no query.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:MINimum:NEXT
Places the marker at the next smaller maximum of the corresponding trace.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:MINimum:RIGHt
Places the delta marker at the next smaller maximum to the right of the current value (that is, in order of
increasing X values).
If required, the corresponding delta marker is first activated.
This command is an event, and therefore has no *RST value and no query.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:MINimum:LEFT
Places the marker at the next smaller maximum to the left of the current value (that is, in order of
decreasing X values) on the trace.
Remote Command
Example
Remote Command Notes
CALCulate<1|2>:MARKer<1...4>:PEXCursion <numeric_value>
The command specifies the peak excursion.
This mode supports only dB units.
92
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:CALCulate[1]:MARKer[1]|2|3|4:MINimum [:PEAK]
CALC:MARK:MIN
FSE, FSP, FSU
:CALCulate[1]:MARKer[1]|2|3|4:MINimum:NEXT
CALC:MARK:MIN:NEXT
FSE, FSP, FSU
CALCulate[1]:MARKer[1]|2|3|4:MAXimum:RIGHt
CALC:MARK:MAX:RIGH
FSE, FSP, FSU
:CALCulate[1]:MARKer[1]|2|3|4:MINimum:LEFT
CALC:MARK:MIN:LEFT
FSE, FSP, FSU