Agilent Technologies X Series User Manual page 43

Compatible SCPI Commands
SCPI Summary Table
Table 3-1
SCPI Command
CALCulate<1|2>:LIMit<1...8>:UPPer:SHIFt
<numeric_value>
CALCulate<1|2>:LIMit<1...8>:UPPer:SPACing
LINear | LOGarithmic
CALCulate<1|2>:LIMit<1...8>:UPPer:THReshol
d <numeric_value>
CALCulate<1|2>:MARKer<1...4>[:STATe] ON |
OFF
CALCulate<1|2>:MARKer<1...4>:AOFF
CALCulate<1|2>:MARKer<1...4>:TRACe 1 to 3
CALCulate<1|2>:MARKer<1...4>:X 0 to MAX
(frequency | sweep time)
CALCulate<1|2>:MARKer<1...4>:X:SLIMits[:S
TATe] ON | OFF
CALCulate<1|2>:MARKer<1...4>:X:SLIMits:LE
FT 0 to MAX (frequency | sweep time)
CALCulate<1|2>:MARKer<1...4>:X:SLIMits:RI
GHT 0 to MAX (frequency | sweep time)
CALCulate<1|2>:MARKer<1...4>:COUNt ON |
OFF
CALCulate<1|2>:MARKer<1...4>:COUNt:RESo
lution 0.1 | 1 | 10 | 100 | 1000 | 10000 Hz
CALCulate<1|2>:MARKer<1...4>:COUNt:FRE
Quency?
CALCulate<1|2>:MARKer<1...4>:LOEXclude
ON | OFF
CALCulate<1|2>:MARKer<1...4>:Y?
CALCulate<1|2>:MARKer<1...4>:Y:PERCent
CALCulate<1|2>:MARKer<1...4>:MAXimum[:P
EAK]
CALCulate<1|2>:MARKer<1...4>:MAXimum:N
EXT
CALCulate<1|2>:MARKer<1...4>:MAXimum:L
EFT
42
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
SCPI Commands Summary Table
Corresponding Support
Model
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSP/FSU Yes
FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSP/FSU Accepted
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
FSE/FSP/FSU Yes
Notes
The unit supported are
DBM and DB.
The only unit supported is
DBM.
Support the parameter
option: 1 | 10 | 100 | 1000 |
10000 | 100000 | 1000000
Hz