Selecting Mode Idn Response - Agilent Technologies X Series User Manual

Front Panel Operations
Mode Setup

Selecting Mode IDN Response

NOTE
To select the response to the command '*IDN?' as what you desire, press the
the front panel and then press
select the response type from the list.
Figure 2-4
The available selections are as follows:
Compatibility
Model
System IDN
Response
User
NOTE
32
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
This selection is active only within the SCPI Language Compatibility mode.
Mode IDN Response
Mode Setup > Mode IDN Response Selection Menu Map
Sets the response to the command '*IDN?' to the model number and firmware version
number that you select from the Compatibility Model list, like
Rohde&Schwarz,FSP-26,123456/789,04.00.
Sets the response to the command '*IDN?' to the model number and firmware version
number of your X-Series analyzer, like 
Agilent Technologies,N9020A,US04000119,A.06.00_R0008.
Sets the response to the command '*IDN?' to the name that you want. To press
enter a name for your case and press
the command '*IDN?', like My Analyzer.
By default, the response is set the same as
a name, the response is also set the same as
The
System IDN Response
response as selected under the
selections apply to the entire instrument, across all modes.
. Figure 2-4 shows the menu map that allows you to
Done , you will get the name when you read from
System IDN Response
System IDN Response
selection refers back to the system-level IDN
key (either
System Factory
hardkey on
Mode Setup
,
User
. If you don't enter
.
or ). These
User