Calculate<1|2>:Limit<1; Ampere| Db | Deg | Rad | S | Hz | Pct | Unitless - Agilent Technologies X Series User Manual

Compatible SCPI Commands
Supported SCPI Commands
State Saved
CALCulate<1|2>:LIMit<1...6>:TRACe <1...3>
The command assigns a limit line to a trace.
The query returns the current assignment.
Remote Command
Example
Remote Command Notes
Preset
State Saved
Min
Max
CALCulate<1|2>:LIMit<1...6>:STATe ON | OFF
The command switches the limit check for the specified limit line on or off.
The limit check result may be queried using CALCulate:LIMit<1...6>:FAIL?.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
CALCulate<1|2>:LIMit<1...6>:UNIT DBM | DBPW | WATT | DBUV | DBMV | VOLT |DBUA |

AMPere| DB | DEG | RAD | S | HZ | PCT | UNITLESS

The command specifies the unit for all limit lines.
This mode supports only the following amplitude units: DBM, DBPW, WATT, DBUV, DBMV, VOLT,
DBUA and DB.
The command ignores the numeric suffix of LIMit, and sets all limit lines to the same unit.
68
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
Saved in instrument state.
:CALCulate[1]:LIMit[1]|2|3|4|5|6:TRACe 1|2|3
:CALCulate[1]:LIMit[1]|2|3|4|5|6:TRACe?
CALC:LIM:TRAC 1
FSE, FSP, FSU
1
Saved in instrument state.
1
3
:CALCulate[1]:LIMit[1]|2|3|4|5|6:STATe ON|OFF|1|0
:CALCulate[1]:LIMit[1]|2|3|4|5|6:STATe?
CALC:LIM:STAT ON
FSE, FSP, FSU
OFF
Saved in instrument state.