Calculate<1|2>:Limit<1 - Agilent Technologies X Series User Manual

This mode does not support any unit for this command.
The query returns the current value of this setting.
Remote Command
Example
Remote Command Notes
Preset
CALCulate<1|2>:LIMit<1...6>:UPPer:SPACing LINear | LOGarithmic
The command switches between linear or logarithmic interpolation for the upper limit line.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
Range
CALCulate<1|2>:LIMit<1...6>:UPPer:THReshold <numeric_value>
The command specifies an absolute threshold value for limit lines with relative Y-axis scaling. The
absolute threshold value is used for the limit check when it exceeds the relative limit value.
This mode supports only dBm units.
The query returns the current value of this setting.
Remote Command
Example
Remote Command Notes
Preset
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SHIFt <real>
CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SHIFt?
CALC:LIM:UPP:SHIF 1
CALC:LIM:UPP:SHIF?
FSE, FSP, FSU
0
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SPACing
LINear|LOGarithmic
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SPACing?
CALC:LIM:UPP:SPAC LIN
CALC:LIM:UPP:SPAC?
FSE, FSP, FSU
LIN
Saved in instrument state.
LINear | LOGarithmic
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:THReshold <ampl>
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:THReshold?
CALC:LIM:UPP:THR 1DBM
CALC:LIM:UPP:THR?
FSP, FSU
–200dBm
Compatible SCPI Commands
Supported SCPI Commands
85