Status:queue[:Next]; System Subsystem; System:communicate:gpib[:Self]:Address; System:communicate:gpib[:Self]:Rterminator Lfeoi | Eoi - Agilent Technologies X Series User Manual

This mode supports the maximum value of 32767, not 65535 as in FSx.
Remote Command
Example
Remote Command Notes
Preset
Min
Max

STATus:QUEue[:NEXT]?

Returns the earliest entry to the error queue then deletes it.
Remote Command
Example
Remote Command Notes

SYSTem Subsystem

This subsystem includes commands for general functions.

SYSTem:COMMunicate:GPIB[:SELF]:ADDRess

Changes the analyzer's IEC/IEEE-bus address.
Changing this address may require further communication to use the new address.
Remote Command
Example
Remote Command Notes
Remote Command Notes
State Saved
Range

SYSTem:COMMunicate:GPIB[:SELF]:RTERminator LFEOI | EOI

Changes the GPIB receive terminator.
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:STATus:QUEStionable:FREQuency:NTRansition <integer>
:STATus:QUEStionable:FREQuency:NTRansition?
STAT:QUES:FREQ:NTR 2
FSE, FSP, FSU
0
0
32767
:STATus:QUEue[:NEXT]?
STAT:QUE?
FSE, FSP, FSU
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <integer>
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess?
:SYST:COMM:GPIB:ADDR 17
Note: Changing the Address on the GPIB port requires all further
communication to use the new address.
FSE, FSP, FSU
No
0 to 30
Compatible SCPI Commands
Supported SCPI Commands
157