Calculate<1|2>:Limit<1; Calculate:limit:lower Subsystem - Agilent Technologies X Series User Manual

Range
CALCulate<1|2>:LIMit<1...6>:CONTrol:SHIFt <numeric_value>
The command shifts the specified limit line in the X-direction, by the specified value.
The query returns the current value of this setting for the specified limit line.
Remote Command
Preset
SCPI Command Notes SCPI
Command Notes
SCPI Example[DEF]SCPI
Example
CALCulate<1|2>:LIMit<1...6>:CONTrol:SPACing LINear | LOGarithmic
The command switches between linear or logarithmic interpolation for calculation of limit lines from
frequency points.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
Range

CALCulate:LIMit:LOWer Subsystem

The CALCulate:LIMit:LOWer subsystem controls the lower limit line.
NOTE
CALCulate<1|2>:LIMit<1...6>:LOWer[:DATA] <numeric_value>,<numeric_value>..
The command defines a set of values for the specified lower limit line.
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
RELative | ABSolute
:CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SHIFt <real>
:CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SHIFt?
0
FSE, FSP, FSU
CALC:LIM:CONT:SHIF 1
CALC:LIM:CONT:SHIF?
:CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SPACing
LINear|LOGarithmic
:CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SPACing?
CALC:LIM:CONT:SPAC LOG
CALC:LIM:CONT:SPAC
FSE, FSP, FSU
LIN
Saved in instrument state.
LINear | LOGarithmic
All limit functions are not supported in the CCDF and APD measurements.
Compatible SCPI Commands
Supported SCPI Commands
79