Calculate:statistics:result<1; Calculate:threshold Subsystem; Calculate<1|2>:Dline<1|2> Minimum; Calculate<1|2>:Dline<1|2>:State On | Off - Agilent Technologies X Series User Manual

Remote Command Notes
CALCulate:STATistics:RESult<1...3>? MEAN | PEAK | CFACtor | ALL
Queries the results of statistical measurements of a recorded trace.
Currently, only TRACE1 is valid for CCDF measurements.
Remote Command
Example
Remote Command Notes

CALCulate:THReshold Subsystem

The CALCulate:THReshold subsystem controls the threshold value for maximum/minimum marker
searches.
CALCulate<1|2>:DLINe<1|2> MINimum...MAXimum
Specifies the position of Display Line 1 or 2. These lines enable the user to mark any levels in the
diagram. The unit depends on the setting made with CALC:UNIT.
This command is accepted, but takes no action and reports no error.
Remote Command
Example
Remote Command Notes
State Saved
CALCulate<1|2>:DLINe<1|2>:STATe ON | OFF
The command turns Display Line 1 or 2 (level lines) on or off.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
FSP, FSU
CALCulate:STATistics:RESult? MEAN|PEAK|CFACtor|ALL
CALC:STAT:RES? ALL
FSP, FSU
:CALCulate[1]:DLINe[1]|2 <ampl>
:CALCulate[1]:DLINe[1]|2?
CALC:DLIN –20DBM
FSE, FSP, FSU
Saved in instrument state.
:CALCulate[1]:DLINe[1]|2:STATe ON|OFF|1|0
:CALCulate[1]:DLINe[1]|2:STATe?
CALC:DLIN:STAT ON
FSE, FSP, FSU
OFF
Saved in instrument state.
Compatible SCPI Commands
Supported SCPI Commands
101