Supported Commands And Queries; Unsupported Commands And Queries - Agilent Technologies X Series User Manual

Getting Started
SCPI Language Compatibility Application General Rules and Limitations

Supported Commands and Queries

Only a subset of the FSE/FSP/FSU series commands is supported in the N9062A/W9062A application.
The list of supported commands was determined by feedback from our customers combined with
technical considerations and constraints.
The supported FSE/FSP/FSU commands are summarized with short notes in
some case, a command is accepted without error, but no action taken, for example, a display line.

Unsupported Commands and Queries

If a command or query is valid for FSE/FSP/FSU products but not supported by the N9062A/W9062A
application, the X-Series analyzer may handle it in the following way:
• Generate an error message. This kind of SCPI commands is not covered in this manual.
NOTE
20
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
If your use case is not fully supported, contact your local Agilent Technologies
Sales and Service Office, or if in the United States, call 1-800-829-4444.
Table 3-1 on page 38. In