Calculate<1|2>:Limit<1; Calculate:limit:upper Subsystem - Agilent Technologies X Series User Manual

Compatible SCPI Commands
Supported SCPI Commands
Example
Remote Command Notes
Preset
CALCulate<1|2>:LIMit<1...6>:LOWer:SPACing LINear | LOGarithmic
The command switches between linear or logarithmic interpolation for the lower limit line.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
Range
CALCulate<1|2>:LIMit<1...6>:LOWer:THReshold <numeric_value>
The command defines an absolute threshold value for limit lines with relative Y-axis scaling.
The absolute threshold value is used for the limit check when it exceeds the relative limit value.
This mode supports only dBm units.
The query returns the current value of this setting.
Remote Command
Example
Remote Command Notes
Preset

CALCulate:LIMit:UPPer Subsystem

The CALCulate:LIMit:UPPer subsystem controls the upper limit line.
82
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
CALC:LIM:LOW:SHIF 1
CALC:LIM:LOW:SHIF?
FSE, FSP, FSU
0
:CALCulate[1]:LIMit[1]|2|3|4|5|6:LOWer:SPACing
LINear|LOGarithmic
:CALCulate[1]:LIMit[1]|2|3|4|5|6:LOWer:SPACing?
CALC:LIM:LOW:SPAC LIN
CALC:LIM:LOW:SPAC?
FSE, FSP, FSU
LIN
Saved in instrument state.
LINear | LOGarithmic
CALCulate[1]:LIMit[1]|2|3|4|5|6:LOWer:THReshold <ampl>
CALCulate[1]:LIMit[1]|2|3|4|5|6:LOWer:THReshold?
CALC:LIM:LOW:THR 1DBM
CALC:LIM:LOW:THR?
FSP, FSU
–200dBm