Agilent Technologies X Series User Manual page 38

3
This chapter lists the IEEE standard SCPI commands and the FSE/FSP/FSU SCPI commands that are
supported by the N9062A/W9062A application on the Agilent X-series analyzers including CXA, EXA,
MXA and PXA and gives brief details on the parameters of the commands.
It's assumed that you have previous experience in programming SCPI. This chapter is not intended to
teach you everything about the SCPI programming language.
If you are not familiar with the SCPI language,
on page 165
If you are using other optional programming compatibility modes, you should refer to the manual that
came with the option.
NOTE
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
Compatible SCPI Commands
contains some useful information.
Most FSE/FSP/FSU SCPI commands have a numeric suffix at the first node,
corresponding to the Split Screen A/B feature, for example, CALCulate<1|2>,
INITiate<1|2> and so on. However, the N9062A or W9062A does not support
suffix "2". That is, Full Screen is assumed, and all commands are mapped as if to
parameter <1>. Besides, the numeric suffix of "1" can be omitted, for example,
CALCulate1 is equal to CALCulate.
If you send a command with the numeric suffix of "2", an error message will be
displayed in the X-Series message area.
Chapter 4 , "A Brief Introduction to the SCPI Language,"
37