Initiate Subsystem; Initiate<1|2>:Continuous On | Off; Initiate<1|2>:Conmeas; Initiate<1|2>[:Immediate] - Agilent Technologies X Series User Manual

Compatible SCPI Commands
Supported SCPI Commands

INITiate Subsystem

The INITiate subsystem controls the init-measurement function.
INITiate<1|2>:CONTinuous ON | OFF
The command switches the trigger system between the continuously-initiated mode (Continuous) or
single measurement mode (Single).
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
INITiate<1|2>:CONMeas
In Single sweep mode, this command resumes a stopped measurement from the current position.
Remote Command
Example
Remote Command Notes
INITiate<1|2>[:IMMediate]
Initiates a new sweep.
Remote Command
Example
Remote Command Notes

INPut Subsystem

The INPut subsystem controls the input characteristics of the instrument's RF inputs.
INPut<1|2>:ATTenuation
The command specifies the input attenuator setting.
With the Electronic Attenuator Option, this mode supports 2 dB steps.
118
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
:INITiate[1]:CONTinuous ON|OFF|1|0
:INITiate[1]:CONTinuous?
:INIT:CONT 0
:INIT:CONT 1
FSE, FSP, FSU
ON
Saved in instrument state.
:INITiate[1]:CONMeas
INIT:CONM
FSE, FSP, FSU
:INITiate[1][:IMMediate]
INIT
FSE, FSP, FSU