Calculate<1|2>:Limit<1 - Agilent Technologies X Series User Manual

NOTE
CALCulate<1|2>:LIMit<1...6>:UPPer[:DATA] <numeric_value>,<numeric_value>..
The command defines a set of values for the specified upper limit line.
This mode does not support any unit for this command.
The query returns the current value set.
Remote Command
Example
Remote Command Notes
State Saved
CALCulate<1|2>:LIMit<1...6>:UPPer:STATe ON | OFF
The command activates or deactivates the specified upper limit line. Limit check is activated separately,
using CALC:LIM:STAT ON.
The query returns the current state of this setting.
Remote Command
Example
Remote Command Notes
Preset
State Saved
CALCulate<1|2>:LIMit<1...6>:UPPer:OFFSet <numeric_value>
The command defines an offset for the Y-axis of the specified relative upper limit line.
This mode does not support any unit for this command.
The query returns the current value of this setting.
Remote Command
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html
All limit functions are not supported in the CCDF and APD measurements.
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer[:DATA]
<real>,<real>...
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer[:DATA]?
CALC:LIM:UPP:DATA –10,0,0,–10,–5
CALC:LIM:UPP:DATA?
FSE, FSP, FSU
Saved in instrument state.
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:STATe ON|OFF|1|0
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:STATe?
CALC:LIM:UPP:STAT OFF
CALC:LIM:UPP:STAT?
FSE, FSP, FSU
OFF
Saved in instrument state.
CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:OFFSet <real>
CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:OFFSet?
Compatible SCPI Commands
Supported SCPI Commands
83