Delta Electronics ASDA-B2 series User Manual page 4

ASDA-B2
The words, DANGER, WARNING and STOP, have the following meaning:
Indicates a potentially hazardous situation and if not avoided, may result in
serious injury or death.
Indicates a potentially hazardous situation and if not avoided, may result in minor
to moderate injury or serious damage to the product.
Indicates an improper action that it is not recommended. Doing so may cause
damage or malfunction.
Unpacking Check

Please ensure that both the servo drive and motor are correctly matched for
size (power rating). Failure to observe this precaution may cause fire, seriously
damage to the drive / motor or cause personal injury.
Installation
 Do not install the product in a location that is outside the stated specification
for the drive and motor. Failure to observe this caution may result in electric
shock, fire, or personal injury.
Wiring
 Connect the ground terminals to a class-3 ground (Ground resistance should
not exceed 100 Ω). Improper grounding may result in electric shock or fire.

Do not connect any power supplies to the U, V, W terminals. Failure to observe
this precaution may result in serious injury, damage to the drive or fire.

Ensure that all screws, connectors and wire terminations are secure on the
power supply, servo drive and motor. Failure to observe this caution may
result in damage, fire or personal injury.
Operation
 Before starting the operation with a mechanical system connected, change the
drive parameters to match the user-defined parameters of the mechanical
system. Starting the operation without matching the correct parameters may
result in servo drive or motor damage, or damage to the mechanical system.

Ensure that the emergency stop equipment or device is connected and
working correctly before operating the motor that is connected to a mechanical
system.
 Do not approach or touch any rotating parts (e.g. shaft) while the motor is
running. Failure to observe this precaution may cause serious personal injury.

In order to prevent accidents, the initial trial run for servo motor should be
conducted under no load conditions (separate the motor from its couplings
and belts).
 For the initial trial run, do not operate the servo motor while it is connected to
its mechanical system. Connecting the motor to its mechanical system may
cause damage or result in personal injury during the trail run. Connect the
servo motor once it has successfully completed a trail run.
 Caution: Please perform trial run without load first and then perform trial run
with load connected. After the servo motor is running normally and regularly
without load, then run servo motor with load connected. Ensure to perform trial
run in this order to prevent unnecessary danger.
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Preface
iii