Delta Electronics ASDA-B2 series User Manual page 196

ASDA-B2
P1-13 TQ2
Operation
Interface:
Default: 100
Control
Mode:
Unit: %
Range: -300 ~ +300
Data Size: 16-bit
Display
Format:
Settings:
2nd Torque Command
In Torque mode, this parameter is used to set torque 2 of internal torque command.
2nd Torque Limit
In Position and Speed mode, this parameter is used to set torque limit 2 of internal
torque command.
P1-14 TQ3
Operation
Interface:
Default: 100
Control
Mode:
Unit: %
Range: -300 ~ +300
Data Size: 16-bit
Display
Format:
Settings:
3rd Speed Command
In Torque mode, this parameter is used to set torque 3 of internal torque command.
3rd Speed Limit
In Position and Speed mode, this parameter is used to set torque limit 3 of internal
torque command.
P1-15 Reserved (Do Not Use)
P1-16 Reserved (Do Not Use)
P1-17 Reserved (Do Not Use)
P1-18 Reserved (Do Not Use)
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
2nd Torque Command or Limit
Keypad/Software
T, P&S
Decimal
3rd Torque Command or Limit
Keypad/Software
T, P&S
Decimal
Chapter 7 Servo Parameters
Communication
Communication
Address: 011EH
Address: 0120H
Address: 0122H
Address: 0124H
Address: 011AH
011BH
Related Section:
Section 6.4.1
Address: 011CH
011DH
Related Section:
Section 6.4.1
011FH
0121H
0123H
0125H
7-31