Delta Electronics ASDA-B2 series User Manual page 240

ASDA-B2
Bit12
Bit12: Input power phase loss detection function
0: Enable Input power phase loss (AL022) detection function
1: Disable Input power phase loss (AL022) detection function
Bit13
Bit13: Encoder output error detection function
0: Enable encoder output error (AL018) detection function
1: Disable encoder output error (AL018) detection function
Bit15 Bit14
Bit14 ~ Bit15: Reserved. Must be set to 0.
P2-66 GBIT2 Special Function 2
Operation
Interface:
Default: 0
Control
Mode:
Unit: N/A
Range: 0 ~ 0xFFFF
Data Size: 16-bit
Display
Format:
Settings:
Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0
Bit0
Bit0: Speed limit accel / decel function
The torque command source is determined by TCM0 and TCM1. When the digital
input, TQP or TQN is used, the torque command is activated by TQP or TQN. When
TQP is ON, the torque will be output directly as the same as the command souce.
For example, when TQP is ON, if the torque command source is an input voltage of
5V and P1-41 is set to 100, it indicates that the torque command is 50% rated torque
until the speed is limited. However, whenTQN is ON, if the torque command source
is an input voltage of 5V and P1-41 is set to 100, it indicates that the torque
command is -50% rated torque until the speed is limited.
Speed limit function can be enabled always by P1-02. When P1-02 is set to 0x10, the
speed limit function can be enabled all the time and the users do not need to use DI,
SPDLM to switch the speed limit function.
The speed limit command is determined by SPD0 and SPD1. The acceleration and
deceleration time is determined by P1-34, P1-35 and P1-36.
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Keypad/Software
PT, S
Hexadecimal
Chapter 7 Servo Parameters
Communication
Address: 0284H
0285H
Related Section: N/A
7-75