Delta Electronics ASDA-B2 series User Manual page 253

Chapter 7 Servo Parameters
1. This adjustment function is enabled after parameter P2-08 is set to 20.
2. When executing any adjustment, the external wiring connected to analog speed or
torque must be removed and the servo system should be off (Servo off).
P4-11 SOF1
Operation
Interface:
Default: Factory setting
Control
Mode:
Unit: N/A
Range: 0 ~ 32767
Data Size: 16-bit
Display
Format:
Settings:
The adjustment functions from P4-11 through P4-19 are enabled after parameter
P2-08 is set to 22. Although these parameters allow the users to execute manual
adjustment, we still do not recommend the users to change the default setting value of
these parameters (P4-11 ~ P4-19) manually.
Please note that when P2-08 is set to 10, the users cannot reset this parameter.
P4-12 SOF2
Operation
Interface:
Default: Factory setting
Control
Mode:
Unit: N/A
Range: 0 ~ 32767
Data Size: 16-bit
Display
Format:
Settings:
Refer to P4-11 for explanation.
Please note that when P2-08 is set to 10, the users cannot reset this parameter.
P4-13 TOF1
Operation
Interface:
Default: Factory setting
Control
Mode:
Unit: N/A
Range: 0 ~ 32767
Data Size: 16-bit
7-88
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Analog Speed Input Drift Adjustment 1
Keypad / Software
ALL
Decimal
Analog Speed Input Drift Adjustment 2
Keypad / Software
ALL
Decimal
Analog Torque Drift Adjustment 1
Keypad / Software
ALL
Communication
Communication
Communication
ASDA-B2
Address: 0416H
0417H
Related Section: N/A
Address: 0418H
0419H
Related Section: N/A
Address: 041AH
041BH
Related Section: N/A
Revision September 2013