Delta Electronics ASDA-B2 series User Manual page 143

Chapter 6 Control Modes of Operation
The parameters P2-23 and P2-24 are the first group of notch filter parameters and
the parameters P2-43 and P2-44 are the second group of notch filter parameters.
P2-43 NCF2
Operation
Interface:
Default: 1000
Control
Mode:
Unit: Hz
Range: 50 ~ 2000
Data Size: 16-bit
Display
Format:
Settings:
This parameter is used to set second resonance frequency of mechanical system. It
can be used to suppress the resonance of mechanical system and reduce the
vibration of mechanical system.
If P2-43 is set to 0, this parameter is disabled.
The parameters P2-23 and P2-24 are the first group of notch filter parameters and
the parameters P2-43 and P2-44 are the second group of notch filter parameters.
P2-44 DPH2
Operation
Interface:
Default: 0
Control
Mode:
Unit: dB
Range: 0 ~ 32
Data Size: 16-bit
Display
Format:
Settings:
This parameter is used to set magnitude of the resonance suppression that is set by
parameter P2-43. If P2-44 is set to 0, the parameters P2-43 and P2-44 are both
disabled.
6-28
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Notch Filter 2 (Resonance Suppression)
Keypad/Software
ALL
Decimal
Notch Filter Attenuation Rate 2
(Resonance Suppression)
Keypad/Software
ALL
Decimal
Communication
Communication
ASDA-B2
Address: 0256H
0257H
Related Section:
Section 6.3.7
Address: 0258H
0259H
Related Section:
Section 6.3.7
Revision September 2013