Delta Electronics ASDA-B2 series User Manual page 180

ASDA-B2
For example:
Set P0-17 to 3, then all consequent reads of P0-09 will return the motor feedback
pulse number in pulse.
When reading the drive status through Modbus communication, the system should
read two 16-bit data stored in the addresses of 0012H and 0013H to form a 32-bit
data.
(0013H : 0012H) = (High Word : Low Word)
When reading the drive ststus through the keypad, if P0-02 is set to 23, VAR-1 will
quickly show for about two seconds and then the value of P0-09 will display on the
display.
P0-10★
CM2
Operation
Interface:
Default: -
Control
Mode:
Unit: -
Range: -
Data Size: 32-bit
Display
Format:
Settings:
This parameter is used to provide the value of one of the status monitoring functions
found in P0-02. The value of P0-10 is determined by P0-18 (desired drive status)
through communication setting or the keypad. The drive status can be read from the
communication address of this parameter via communication port.
When reading the drive status through the keypad, if P0-02 is set to 24, VAR-2 will
quickly show for about two seconds and then the value of P0-10 will display on the
display.
P0-11★
CM3
Operation
Interface:
Default: -
Control
Mode:
Unit: -
Range: -
Data Size: 32-bit
Display
Format:
Settings:
This parameter is used to provide the value of one of the status monitoring functions
found in P0-02. The value of P0-11 is determined by P0-19 (desired drive status)
through communication setting or the keypad. The drive status can be read from the
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Status Monitor 2
Keypad/Software
ALL
Decimal
Status Monitor 3
Keypad/Software
ALL
Decimal
Chapter 7 Servo Parameters
Communication
Communication
Address: 0014H
0015H
Related Section:
Section 4.3.5
Address: 0016H
0017H
Related Section:
Section 4.3.5
7-15