Delta Electronics ASDA-B2 series User Manual page 298

ASDA-B2
Display
Serial communication error
Serial communication time
out
Reserved
Input power phase loss
Pre-overload warning
Encoder initial magnetic
field error
Encoder internal error
Encoder data error
Motor internal error
Motor internal error
Motor internal error
Motor protection error
U,V,W, GND wiring error
Motor temperature error
Excessive encoder output
error
Motor temperature warning
DSP firmware upgrade
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Fault Name Clearing Method
Turn ARST (DI signal) ON to clear the fault.
This fault message can also be removed
automatically after the communication is
normal.
Turn ARST (DI signal) ON to clear the fault
or restart the servo drive.
This fault message cannot be cleared.
Turn ARST (DI signal) ON to clear the fault.
This fault message can be removed
automatically after input power phase lost
problem is solved.
Turn ARST (DI signal) ON to clear the fault
or restart the servo drive.
This fault message can be removed by
restarting the servo drive.
This fault message can be removed by
restarting the servo drive.
This fault message can be removed by
restarting the servo drive.
This fault message can be removed by
restarting the servo drive.
This fault message can be removed by
restarting the servo drive.
This fault message can be removed by
restarting the servo drive.
Turn ARST (DI signal) ON to clear the fault.
This fault message can be removed by
restarting the servo drive.
This fault message can be removed by
restarting the servo drive.
Turn ARST (DI signal) ON to clear the fault.
This fault message can be removed after
temperature drops to normal degree.
This fault message can be removed after
setting P2-08 to 30 first, and then 28 next
and restarting the servo drive.
Chapter 9 Troubleshooting
9-13