Delta Electronics ASDA-B2 series User Manual page 131

Chapter 6 Control Modes of Operation
Display
Format:
Settings:
This parameter is used to determine the acceleration time to accelerate from 0 to its
rated motor speed. The functions of parameters P1-34, P1-35 and P1-36 are each
individual.
Please note:
1. When the source of speed command is analog command, the maximum setting
value of P1-36 is set to 0, the acceleration and deceleration function will be
disabled.
P1-35 TDEC Deceleration Time
Operation
Interface:
Default: 200
Control
Mode:
Unit: ms
Range: 1 ~ 20000
Data Size: 16-bit
Display
Format:
Settings:
This parameter is used to determine the acceleration time to accelerate from 0 to its
rated motor speed. The functions of parameters P1-34, P1-35 and P1-36 are each
individual.
Please note:
1. When the source of speed command is analog command, the maximum setting
value of P1-36 is set to 0, the acceleration and deceleration function will be
disabled.
P1-36 TSL
Operation
Interface:
Default: 0
Control
Mode:
Unit: ms
Range: 0 ~ 10000 (0: Disabled)
Data Size: 16-bit
Display
Format:
6-16
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Decimal
Keypad/Software
S
Decimal
Accel /Decel S-curve
Keypad/Software
S
Decimal
Communication
Communication
ASDA-B2
Address: 0146H
0147H
Related Section:
Section 6.3.3
Address: 0148H
0149H
Related Section:
Section 6.3.3
Revision September 2013